Truman Brothers
- MLGking1221
- mlgking1221
- Europe/Stockholm
- Yes
- No
REALMS-1726
what should of happened: piston should of pulled back
what happened: after removing the power source it still was activated
steps to reproduce
step1: place a sticky piston facing down 3 blocks off the ground
step2: place a stone block on top of the piston with a daylight sensor on day mode on top
step3: place a stone block next to piston with a redstone torch on top
step4: place a stone block on the bottom on the piston (on the sticky side)
step5: place redstone torch 2 blocks away from the piston on the ground
step6: place a repeater facing into the stone block on the ground
step7: break the daylight sensor them break the redstone torch on the stone block
it should stay extended out
if this is confusing there are some pictures
I found this may not work for some odd reason but it should but the picture shows its real
what should of happened: piston should of pulled back
what happened: after removing the power source it still was activated
steps to reproduce
step1: place a sticky piston facing down 3 blocks off the ground
step2: place a stone block on top of the piston with a daylight sensor on day mode on top
step3: place a stone block next to piston with a redstone torch on top
step4: place a stone block on the bottom on the piston (on the sticky side)
step5: place redstone torch 2 blocks away from the piston on the ground
step6: place a repeater facing into the stone block on the ground
step7: break the daylight sensor them break the redstone torch on the stone block
it should stay extended out
if this is confusing there are some pictures
I found this may not work for some odd reason but it should but the picture shows its realwhat should of happened: piston should of pulled back
what happened: after removing the power source it still was activated
steps to reproduce
step1: place a sticky piston facing down 3 blocks off the ground
step2: place a stone block on top of the piston with a daylight sensor on day mode on top
step3: place a stone block next to piston with a redstone torch on top
step4: place a stone block on the bottom on the piston (on the sticky side)
step5: place redstone torch 2 blocks away from the piston on the ground
step6: place a repeater facing into the stone block on the ground
step7: break the daylight sensor them break the redstone torch on the stone block
it should stay extended out
if this is confusing there are some pictures
this works in the overwould too
I found this may not work for some odd reason but it should but the picture shows its real
what should of happened: piston should of pulled back
what happened: after removing the power source it still was activated
steps to reproduce
step1: place a sticky piston facing down 3 blocks off the ground
step2: place a stone block on top of the piston with a daylight sensor on day mode on top
step3: place a stone block next to piston with a redstone torch on top
step4: place a stone block on the bottom on the piston (on the sticky side)
step5: place redstone torch 2 blocks away from the piston on the ground
step6: place a repeater facing into the stone block on the ground
step7: break the daylight sensor them break the redstone torch on the stone block
it should stay extended out
if this is confusing there are some pictures
this works in the overwould too
I found this may not work for some odd reason but it should but the picture shows its real